Best whole house water filter for well water, picked by what your test shows

The iron and hydrogen sulfide lines on a lab report decide which of these filters fits your well.

Last reviewed November 2026

Most wells with iron from 3 to 7 ppm, or a lab-confirmed hydrogen sulfide reading of 8 ppm or less, should get the SpringWell WS1, which oxidizes iron, manganese and hydrogen sulfide in one tank with no salt or chemical feed; SpringWell rates it to 7 ppm iron, 1 ppm manganese and 8 ppm hydrogen sulfide. Below 3 ppm iron, with manganese at 1 ppm or less and no hydrogen sulfide on the report, the cartridge-based iSpring WGB32BM costs under a quarter as much up front. A well whose only complaint is sand or silt, with iron and manganese under the EPA’s secondary standards, needs just the two-stage iSpring WGB21B.

On a lab report, mg/L and ppm are the same amount. Test before buying any of these: the CDC and EPA both recommend a yearly well test for coliform bacteria, nitrate, total dissolved solids and pH.

SpringWell adds its required well water test to the WS1 at checkout, on top of the system price.

  SpringWell WS1 iSpring WGB32BM iSpring WGB21B
Best for Iron 3 to 7 ppm, or hydrogen sulfide up to 8 ppm Iron below 3 ppm, no hydrogen sulfide Sand and silt in a low-iron well
How it works Air injection oxidation in a backwashing tank Three cartridges: 5-micron sediment, carbon block, catalytic iron and manganese media Two cartridges: 5-micron sediment, carbon block
Rated limits Iron 7 ppm, manganese 1 ppm, hydrogen sulfide 8 ppm Iron 3.0 ppm, manganese 1.0 ppm No iron or manganese rating
Flow and size 12 GPM, homes with 1 to 4 bathrooms Up to 15 GPM listed, 1-inch ports Flow not listed; 1-inch ports, 10-inch cartridges
Upkeep Automatic backwash, no cartridges 20-inch sediment and carbon cartridges rated 100,000 gallons; iron cartridge replaced on iSpring’s schedule 10-inch cartridges rated 50,000 gallons
Price $2,231.25 $473.68 $155.15
  WS1 from SpringWell, $2,231.25 WGB32BM on Amazon, $473.68 WGB21B on Amazon, $155.15
Ratings, flow and capacity are the manufacturers’ published figures. Prices checked November 9, 2026 on springwellwater.com and Amazon; the WS1 price excludes SpringWell’s required test and optional add-ons.

At exactly 3 ppm iron the WGB32BM has no margin left, so the WS1 is the safer fit. Manganese above 1 ppm is outside both iron units’ ratings; the manganese guide covers that result.

Before you buy anything. This page is educational and is not a substitute for certified laboratory water testing or the advice of a licensed water-treatment or well professional. The EPA notes that private wells are not regulated under the Safe Drinking Water Act, so the owner is responsible for testing. None of the filters on this page disinfects water, softens it, or removes nitrate or arsenic. Nothing here is medical advice.

Pick the WS1 if

Iron tests from 3 to 7 ppm, or the cold water smells of rotten eggs and a lab puts hydrogen sulfide at 8 ppm or less, with manganese at 1 ppm or less. A smell that fades as the tap runs points to sulfur bacteria instead, covered in the rotten egg smell guide.

Choose the WGB32BM when

Iron is below 3 ppm, manganese 1.0 ppm or less, and the report shows no hydrogen sulfide. You change cartridges and skip the drain line a backwashing tank needs.

A sediment-only well

Iron under 0.3 mg/L and manganese under 0.05 mg/L, the EPA secondary standards, with grit or cloudiness from the pump, is the WGB21B’s job.

Get a lab report before you size a filter

Use a state-certified laboratory for the yearly test. For a filter decision, ask the same lab to add iron, manganese, hardness and hydrogen sulfide. Hydrogen sulfide escapes from an open bottle, so use the lab’s own container and instructions for that one.

Any measurable hydrogen sulfide rules out both cartridge units, since neither carries a rating for it. Penn State Extension says water below 7 grains per gallon probably won’t cause major scaling, so a higher hardness result is the point to consider a softener as well. How to read your water test maps the rest of a report to treatment categories, and the well water test kit guide covers where to send the sample.

How iron and sulfur narrow the choice

Dissolved iron is invisible until it meets oxygen, then turns into the orange particles that stain fixtures. Every iron filter forces that change inside the unit and traps what forms. Penn State Extension matches the method to the level: catalytic carbon below 1.0 mg/L when the water carries at least 4.0 mg/L of dissolved oxygen, oxidizing filters from 3 to 10 mg/L of iron and manganese combined, and chemical oxidation followed by filtration above 10 mg/L.

The two picks for iron sit partly outside those bands. iSpring rates its catalytic cartridge to 3.0 ppm, above the 1.0 mg/L Penn State gives for catalytic carbon, and iSpring’s listing says nothing about the dissolved oxygen Penn State’s figure assumes. Penn State lists aeration among other iron methods without a concentration range, and SpringWell’s air injection ratings are its own. Penn State also counts iron and manganese together, while both manufacturers rate each one separately. Penn State gives no range between 1 and 3 mg/L, which is where the WGB32BM’s own rating does the work. The iSpring and SpringWell ratings are manufacturer figures, so confirm them with a retest of treated water.

For hydrogen sulfide, Penn State puts activated carbon below about 1 mg/L and aeration up to about 2 mg/L; for greensand oxidizing filters, Penn State says up to 2 to 3 mg/L and the Minnesota Department of Health says up to about 6 mg/L. SpringWell’s 8 ppm rating for the WS1 goes past all of those and is also the manufacturer’s own figure. If only the hot taps smell, the rotten egg smell guide explains why the water heater is the likely source.

What a well filter does not handle

Coliform bacteria call for disinfection, and an oxidizing or cartridge filter is not a disinfection device. Ultraviolet units are certified under NSF/ANSI 55 in two classes. The Ohio Department of Health describes Class A units as built to inactivate disease-causing bacteria and viruses at a minimum dose of 40 mJ/cm², and Class B units at 16 mJ/cm² as meant only for nuisance organisms in water already considered safe. Ohio’s private water system rule allows only Class A units for continuous disinfection, requires a filter of 5 microns or finer ahead of the lamp, and places the UV unit after any softener or iron filter.

Nitrate and arsenic carry enforceable EPA limits of 10 mg/L as nitrogen and 10 parts per billion. Oxidizing filters and softeners leave both in the water. Arsenic needs reverse osmosis, activated alumina or arsenic-rated anion exchange, and MassDEP notes that arsenic III has to be oxidized to arsenic V first, because reverse osmosis does not effectively remove arsenic III; the arsenic guide covers the test for the form. Nitrate needs reverse osmosis, nitrate-selective anion exchange or distillation. If bacteria come back positive, or nitrate or arsenic above those limits, call your county health department first.

Our picks

Best for iron and sulfur: SpringWell WS1

Best forHomes with 1 to 4 bathrooms on a well with iron from 3 to 7 ppm or lab-confirmed hydrogen sulfide. The tank draws in an air pocket that oxidizes the water as it passes, and a backwash flushes the trapped particles to drain. SpringWell lists its well water test as a required add-on.
Skip ifAny reading exceeds its ratings, or iron bacteria slime has not been cleaned out of the well and retested. It does not address coliform bacteria, lead, arsenic, PFAS or nitrate.
WS1 Well Water Filter from SpringWell, $2,231.25

Best for low iron on a budget: iSpring WGB32BM

Best forA DIY install on a low-iron well. The fittings are 1-inch NPT, and iSpring says its catalytic media is not consumed the way greensand is.
Skip ifIron runs above 3 ppm or the cold water smells of rotten eggs. Cartridges are a recurring cost, and iSpring’s warranty runs one year.
iSpring WGB32BM Iron Filter on Amazon, $473.68

Best when sediment is the only problem: iSpring WGB21B

Best forA well that sends sand or silt through the lines and tests clean otherwise. Its 5-micron first stage also meets the prefilter size Ohio’s rule calls for ahead of a UV unit.
Skip ifYour report shows iron above 0.3 mg/L or manganese above 0.05 mg/L. Without an oxidizing stage, dissolved iron passes through and stains fixtures downstream.
iSpring WGB21B Sediment Filter on Amazon, $155.15

Softener sizing for a hard well is in the well water softener guide. Iron above 7 ppm, and the softener route for removing iron, are covered in the iron filter guide.

Common questions

Can I use a city-water whole house filter on a well?

Carbon systems built for municipal water target chlorine, chloramine and taste, and they carry no iron, manganese or hydrogen sulfide rating, so on a well they suit only water already low in iron and manganese, the case the WGB21B is picked for.

Do I need a UV system as well?

Only if testing shows coliform bacteria, or your health department recommends one. When you add it, choose an NSF/ANSI 55 Class A unit and install it after the filter and any softener.

Will one of these filters soften my water?

No. Calcium and magnesium pass through oxidizing and cartridge filters alike, so softening is a separate step.

How do I know the filter is working?

Send a sample of treated water to the lab for iron, manganese and hydrogen sulfide a few weeks after installation, and compare it with the original report.

Disclosure: this page contains affiliate links, and we may earn a commission if you buy through them, at no extra cost to you. Picks rest on each system’s published ratings and the problem it targets; the editorial policy covers sourcing. Sources: CDC and EPA for testing; Penn State Extension and the Minnesota Department of Health for treatment ranges; MassDEP for arsenic treatment; the Ohio Department of Health and Ohio Administrative Code 3701-28-15 for UV; SpringWell and iSpring for system ratings.