Best iron filter for well water by iron level

Sorted by the iron number on your lab report, with pH and hardness deciding the one case where a softener can do the job.

Last reviewed October 2026

From 3 ppm up to 7 ppm of iron, or with a sulfur smell at any iron level, the SpringWell WS1 is our pick. SpringWell rates it to 7 ppm iron, 1 ppm manganese and 8 ppm hydrogen sulfide, and it runs without salt or chemicals. Below 3 ppm with no sulfur smell, the cartridge-based iSpring WGB32BM costs about a fifth as much. The AFWFilters Iron Pro 2 covers hard, clear water with dissolved iron under 5 mg/L, removing the iron and the hardness in one tank.

On a lab report, mg/L and ppm are the same amount. The EPA’s secondary standard for iron is 0.3 mg/L, set for staining and taste; Penn State Extension says iron is not a health concern in drinking water.

The WS1 price is the system alone; SpringWell adds its required well water test at checkout.

  SpringWell WS1 AFWFilters Iron Pro 2 iSpring WGB32BM
Method Air injection oxidation, backwashing tank Ion-exchange softener with fine mesh resin, Fleck 5600SXT metered valve Catalytic iron and manganese cartridge after sediment and carbon stages
Iron rating 7 ppm Up to the 4 to 7 ppm range (listing); Penn State limits softener removal to under 5 mg/L 3.0 ppm
Manganese rating 1 ppm Up to 6 ppm (listing claim) 1.0 ppm
Also treats Hydrogen sulfide to 8 ppm Hardness, 48,000 grain capacity Sediment to 5 microns
Uses salt No Yes No
Price $2,231.25 $815.00 $473.68
  WS1 from SpringWell, $2,231.25 Iron Pro 2 on Amazon, $815.00 WGB32BM on Amazon, $473.68
Ratings are manufacturer and listing figures; the softener limit is from Penn State Extension, Iron and Manganese in Private Water Systems. Prices checked November 9, 2026 on springwellwater.com and Amazon.

Above 7 ppm iron, no pick on this page carries a maker’s rating for your water.

Before you buy anything. This page is educational and is not a substitute for certified laboratory water testing or the advice of a licensed water-treatment or well professional. Orange stains say nothing about coliform bacteria, nitrate or arsenic, which the EPA and CDC tell well owners to test for separately. None of these systems treats them. Nothing here is medical advice.

3 to 7 ppm, or any sulfur smell

The WS1 is the only pick here with a hydrogen sulfide rating.

Hard, clear water with iron

When the water is hard and all four softener conditions below hold, the Iron Pro 2 does the work of a filter and a softener, so it wins at any iron level under 5 mg/L.

Below 3 ppm, no odor, soft water

A WGB32BM on the wall is the lowest-priced pick here.

Read the whole report before you choose

A softener can remove iron only under four conditions Penn State Extension spells out: pH above 6.7, hardness of 3 to 20 grains per gallon, dissolved iron below 5 mg/L, and raw water that reaches the softener before it meets air or chlorine. Those are the conditions the Iron Pro 2 needs. So order iron, manganese, pH and hardness on the same test, plus hydrogen sulfide if the cold water smells.

Look at the water in a glass too. Water that comes out clear and turns orange after standing carries dissolved iron. Water that is orange or cloudy at the tap carries iron that has already oxidized, and oxidized iron fouls softener resin, which rules the Iron Pro 2 out for that well. Our iron in well water guide walks through both forms and the slime that points to iron bacteria.

Match the treatment to the lab number

Below about 2 mg/L of dissolved iron, polyphosphate feed holds the iron in solution without removing it. Catalytic carbon handles dissolved iron below 1.0 mg/L when the water carries at least 4.0 mg/L of dissolved oxygen. Oxidizing filters cover combined iron and manganese from 3 to 10 mg/L, and above 10 mg/L combined, chlorine, potassium permanganate or hydrogen peroxide oxidizes the iron before a filter catches it. All of those ranges come from Penn State Extension.

The picks here carry their own manufacturer ratings, and two of them sit outside Penn State’s bands. iSpring rates its catalytic cartridge to 3.0 ppm, which covers the 1 to 3 mg/L stretch where Penn State’s filter list names no removal method, though iSpring’s listing does not mention the dissolved oxygen Penn State’s catalytic figure assumes. SpringWell’s air injection approach is not on the list at all, and both makers rate iron and manganese separately where Penn State counts them together. Retest the treated water to confirm either one.

Iron between 7 and 10 ppm may still fall inside Penn State’s oxidizing-filter band, which counts iron and manganese together up to 10 mg/L, but it is past every rating on this page. That calls for a larger oxidizing system or chemical feed, sized on site by a water-treatment professional.

Clean out iron bacteria first

Slime in the toilet tank or an oily sheen on standing water points to iron bacteria, and the Minnesota Department of Health says only a laboratory test confirms them. MDH describes well cleaning by a licensed contractor followed by shock chlorination as the usual response, and notes it may need repeating. A filter installed on an untreated well clogs with that slime, so clean, chlorinate and retest before any of these goes in.

Our picks

Best overall iron filter: SpringWell WS1

Best forWells with more iron than a cartridge can take, especially when manganese or a sulfur smell is in the report too. The tank draws in an air pocket that oxidizes the iron, and a backwash flushes the trapped particles to drain. Sized for 1 to 4 bathrooms at 12 GPM.
Skip ifManganese runs above 1 ppm, or iron bacteria have not been treated. It does not soften water or address coliform bacteria, lead, arsenic, PFAS or nitrate. Hard water with 5 to 7 ppm of iron can pair it with a softener downstream.
WS1 Well Water Filter from SpringWell, $2,231.25

Best for iron plus hard water: AFWFilters Iron Pro 2

Best forOne tank for dissolved iron and hardness together. It pairs a 48,000 grain bed of fine mesh resin with a Fleck 5600SXT valve that regenerates by metered use. The listing claims iron up to the 4 to 7 ppm range; Penn State’s limit for softener removal is under 5 mg/L, so size to that.
Skip ifThe water is orange at the tap, pH is 6.7 or lower, hardness falls outside 3 to 20 grains per gallon, or a sulfur smell is present. Regeneration uses salt, and Penn State notes each cycle runs about 50 gallons of water, which can add load to a septic drainage field.
AFWFilters Iron Pro 2 on Amazon, $815.00

Best budget iron filter: iSpring WGB32BM

Best forLight iron with no odor. iSpring says its catalytic media is not consumed the way greensand is, and lists flow up to 15 GPM through 1-inch ports, with a 5-micron sediment cartridge and a carbon block ahead of the iron stage.
Skip ifIron is above 3.0 ppm, or the water smells of sulfur. Plan on buying replacement cartridges.
iSpring WGB32BM Iron Filter on Amazon, $473.68

Black or brown-black stains point to manganese, covered in the manganese guide. For a sediment-only well, see the whole house well filter guide.

Common questions

Will any water softener remove iron?

Only dissolved iron below 5 mg/L, under the four conditions above, according to Penn State, which also warns that oxidized iron fouls resin. The Iron Pro 2 listing describes its fine mesh resin as designed for high iron removal.

My iron is 9 ppm. What should I buy?

None of the three here is rated that high. If iron and manganese together stay at or below 10 mg/L, an oxidizing system sized for that load fits Penn State’s band, and above 10 mg/L of iron and manganese combined, Penn State points to chemical oxidation followed by filtration. Have a water-treatment professional size either one on site.

How long until the stains stop?

Existing stains stay until cleaned. Retest the treated water; iron should read under 0.3 mg/L, the EPA’s secondary standard.

Disclosure: this page contains affiliate links, and we may earn a commission if you buy through them, at no extra cost to you. Picks rest on each system’s published ratings and the problem it targets; the editorial policy covers sourcing. Sources: EPA for the iron standard; Penn State Extension for treatment ranges; the Minnesota Department of Health for iron bacteria; SpringWell, AFWFilters and iSpring for system ratings.